Wireless Tutorials

♦Connect to the Auraria Campus Wi-Fi

♦Open your browser and go to the following webpage:

     metrostatewireless.msudenver.edu

♦The introduction page will open, explaining what the wizard will do

♦Click on End-User License Agreement to read the agreement

♦When you have read and agreed to the terms and conditions, close the window and back in the Welcome To Our Secure Wireless Service window, check the box next to I accept the terms of the End-User License Agreement

♦Click Start

♦XpressConnect will begin loading

♦A security window may open, if it does, click Run.

♦The XpressConnect Wizard will open in  a new window

♦You will then be asked to enter your credentials. 

- If you are faculty or staff, use your admin username and password. 

- If you are a student, use your academic username and password (The same as ConnectU)

♦ Click Continue

♦The XpressConnect Wizard will the automatically go through the next steps as it verifies the computer’s configuration, connects to the network, and validates the connectivity

 ♦When it is finished you will be alerted that the connection was successful, and your browser will automatically open to the Metropolitan State University of Denver’s homepage

♦Connect to the Auraria Campus Wi-Fi

♦Open your browser and go to the following webpage:

   metrostatewireless.msudenver.edu

♦The introduction page will open, explaining what the wizard will do

♦Click on End-User License Agreement to read the agreement

♦When you have read and agreed to the terms and conditions, close the window and back in the Welcome To Our Secure Wireless Service window, check the box next to I accept the terms of the End-User License Agreement

♦Click Start

♦The XpressConnect Wizard will open

♦Select the network you wish to join

-If you are faculty or staff, select Faculty and Staff Test_MetroStateSecure

-If you are a student, select Students Test_MetroStateSecure

♦Click Continue

♦A window will open indicating that the Network Wizard wants to make changes, enter your username and password

-If you are using a school computer you will enter your credentials, either administrative or academic.

-If you are using your personal computer, you will enter your username and password for your computer.

♦Click OK when you are done

♦In the Configure step, you will be notified that in order to access the secured network, SafeConnect must be installed onto your computer. Below that is a list of information that SafeConnect will collect from your computer when you connect to the Wi-Fi

♦Click Install

♦The Mac Installer will automatically open, this will walk you through the installation process

-Under the Introduction step > click  Continue

-Under the Destination Select step > select the disk where you want to install the software > click Continue

-Under the Installation Type step, click Install

♦You will be asked to type your username and password for your computer

-Note: If you are downloading this on a school computer, you must have administrative rights for that computer

♦Click Install Software when you are done

♦The installation process will finish, click Close

♦ Back in the XpressConnect window, the Wizard will automatically take you through the Authenticate and Validate Connectivity steps

♦When it is finished, you will get a message notifying you that you have successfully connected, click Done